| 1. |
Remove the upper and side trim from the
tailgate frame.
|
| 2. |
Remove the tailgate trim panel after removing
4 screws.
|
| 3. |
Remove the rear wiper arm after removing a
nut.
Tightening
torque
14~17 Nm (140~170 kg•cm, 10.3~12.5
lb•ft)
| |
| 4. |
Remove the hexagonal nut after removing pivot
cover.
Tightening
torque
14~17 Nm (140~170 kg•cm, 10.3~12.5
lb•ft)
| |
| 5. |
Remove the rear wiper motor after removing 3
bolts, and disconnect the motor's connector.
|
| 1. |
Installation is the reverse of
removal. |
| 2. |
Set the washer nozzle on the specified spray
position.
|
| 1. |
Remove the connector from the rear wiper
motor. |
| 2. |
Connect battery positive (+) and negative (-)
cables to terminals 3 and 4
respectively. |
| 3. |
Check that the motor operates normally.
Replace the motor if it operates
abnormally. |
|
